Eco Friendly Systems Specs and Install Instructions

The Eco Friendly Water Softeners and Filtrattion Products are a up-flow systems, therefore, the inlet and outlet connections are opposite of traditional water treatment equipment.The flow rate must not exceed the maximum specified flow rate of the system. A flow control device will be required for applications where flow rates exceed the maximum specified flow rate.

 

Equipment Sizing Chart
Part Number	Tank Size	Pipe Size	Max Service Flow
M8408-RES	8X35	1"	10 gpm
M8409-RES	9X35	1"	12 gpm
M8410-RES	10X54	1"	15 gpm
M8412-RES	12X52	1"	20 gpm
M8413-RES	13X54	1"	25 gpm

 

 

Installation Instructions

• Place system on a smooth flat surface
• Install the fittings and / or the bypass. Slide the nut on first then the split ring and o-ring
• Connect incoming cold water to the inlet of the system
• Connect system outlet to service water of the house
• Partially open a valve down stream of the system to allow the air to purge from system
• Slowly open inlet valve and allow the system to fill with water
• Close the downstream valve five minutes after all the air has been purged form the system and plumbing. This flushes the fines out of the system.
• Check for leaks and repair if required
• System is ready for use

 

Conditions for Operations

• Minimum pressure 15 PSI
• Maximum pressure 125 PSI
• Minimum operating temperature 34 F
• Maximum operating temperature 120 F
• Water pH range 6.0 to 9.0
• Maximum feed water hardness 50 grains per gallon
• Hydrogen sulfide and iron-pretreatment required
• Maximum chlorine 3 ppm-de-chlorination recommended
• Residential systems are designed for intermittent flow-for continuous flow use commercial OneFlow system